Please consider registering
guest

sp_LogInOut Log In sp_Registration Register

Register | Lost password?
Advanced Search

— Forum Scope —




— Match —





— Forum Options —





Minimum search word length is 3 characters - maximum search word length is 84 characters

sp_Feed Topic RSS sp_TopicIcon
new dometic air compressor will not cycle on and off
August 11, 2013
6:24 pm
suncanoe
New Member
Members
Forum Posts: 1
Member Since:
August 11, 2013
sp_UserOfflineSmall Offline

I HAVE HAD A NEW MARINEAIIIR VECTOR TURBO HEAT/COOL AC INSTALLED IN MY 3807 1988 CARVER AFT CABIN MOTORYACHT.  I HAD A 9,000 MARINEAIRRE ORIGINALLY, BUT HAD TO REPLACE IT WITH A  10,000 SINCE THE 9,000 WAS NO LONGER AVAILABLE.  THIS WAS INSTALLED IN THE AFT CABIN OF THE BOAT.  I HAVE THE THREE KNOB CONTROL SYSTEM, BUT CANNOT SEEM TO GET THE SENSOR LOCATED PROPERLY THUS THE COMPRESSOR RUNS CONSTANTLY AND WILL NOT RECYCLE.   THE OLD SENSOR WAS LOCATED ON THE EVAPORATOR FACE, BUT Frown THE REVERSING VALVE AND HIGH SIDE AND LOW SIDE LINES MAKE IT IMPOSSIBLE TO PLACE THE SENSOR IN THE SAME PLACE AS THE OLD ONE WAS.  I WOULD LIKE YOUR SUGGESTION TO ALLEVIATE THIS PROBLEM.  I DIDN'T INSTALL THE UNIT, BUT WAS A HVAC TECH FOR MANY YEARS, JUST NOT ON MARINE AIR.  AM I OVERLOOKING SOMETHING SIMPLE.  THIS UNIT IS STILL IN WARRANTY. Confused